We offer a line of out of the
box floor and wall hanging models that are designed
for ease of installation.
Our floor models will be shipped to you in one carton fully assembled. It will
simply be a matter of placing the unit in the desired location, filling the base
pool with sufficient water to cover the submerged light and pump and plugging
it in to a 100 volt outlet.
Some of our smaller floor models have separate parts that will require installation
but a complete, easy to follow, instruction manual will accompany those shipments.
Our wall hanging models will also be shipped
in one carton. These models will have either
one or two mounting brackets that must be affixed
to wall studs. The frame of the units are then
just hung on the brackets. To avoid having
power cords hanging below the water feature
it is best to install an outlet behind the
feature into which the cord can be plugged.
For convenience sake it is best to have a remote
switch connected to the power line.
Please be sure to keep the submerged light
and pump covered with water at all times. This
will require frequent replacement of the water
that is lost through evaporation. The rate
of evaporation will depend on the environment
into which the unit is placed.
If there are any questions regarding installation
please contact our customer
service line at 1-888-255-5570 or locally